Καλώδιο δικτύου Flexline FL31-29056 Cat6a U/FTP (STP) 5 m RJ-45 σε RJ-45

Flexline FL31-29056 Cat6a U/FTP (STP) 5 m RJ-45 to RJ-45 is a shielded Ethernet patch cable designed for high-speed network connections. The cable supports data transmission rates up to 10,000 Mbit/s and is fitted with gold-plated RJ-45 contacts on both ends to maintain consistent signal integrity. The U/FTP (STP) shielding reduces electromagnetic interference, making the cable suitable for environments where improved EMI protection is required.

Advantages

The cable combines Category 6a performance with overall and pair-level shielding to provide stable throughput at 10 Gbps over short distances. Gold-plated contacts ensure low contact resistance and corrosion resistance for long-term reliability. The 5 m length offers a balance between flexibility and reach for rack-to-desk or equipment-to-equipment connections while maintaining signal quality thanks to the construction and shielding.

Suitable for

• High-speed Ethernet links up to 10 Gbit/s
• Data center patching and rack connections
• Office LAN cabling and switch-to-workstation links
• Home gigabit networks requiring improved EMI protection

Key specifications

• Category: Cat6a (augmented Category 6)
• Shielding: U/FTP — overall shield with individually shielded pairs (STP)
• Connector type: RJ-45 on both ends with gold-plated contacts
• Length: 5 metres
• Maximum supported data rate: up to 10,000 Mbit/s (10 Gbit/s)
• Typical applications: Ethernet, data center patching, LAN connections

How to use

Insert the RJ-45 connector into the compatible Ethernet port until it clicks, ensuring the latch is fully engaged. Use the cable for direct patching between switches, routers, servers and workstations or within patch panels and network racks. Route the cable to avoid tight bends and excessive mechanical stress; maintain recommended bend radius to preserve shielding and internal pair geometry. Disconnect by depressing the latch and gently pulling the connector straight out.

Recommendations

For best performance, avoid running the cable parallel to power lines or sources of strong electromagnetic interference. Use cable management in racks and conduits to maintain bend radius and prevent stretching. Verify link speed and duplex settings on connected equipment after installation to ensure the system negotiates the intended 10 Gbit/s connection where supported.