Πομποδέκτης SFP+ CBO SFP-10G-BX-D-40KM-NG-BO 10 Gbit/s LC Singlemode 40 km

SFP+ CBO SFP-10G-BX-D-40KM-NG-BO is a 10 Gbit/s small form-factor pluggable transceiver with an LC duplex interface for single-mode fiber designed to support long-distance optical links up to 40 km. The module fits standard SFP+ ports and enables hot-swappable installation for use in switches, routers and optical line cards. It is intended for high-speed uplinks, aggregation links and inter-site connections where 10 Gbit/s bandwidth and single-mode transmission are required.

Advantages

The transceiver provides a compact, hot-pluggable solution for 10 Gbit/s single-mode fiber connections with low power consumption and industry-standard form factor compatibility. Its LC connector and single-mode design allow consistent performance over long distances up to 40 km. The module supports straightforward integration into existing network hardware that accepts SFP+ optics, enabling fast replacement and minimal downtime.

Suitable for

• Data center uplinks and server-to-switch connections
• Metro and access networks requiring 10 Gbit/s single-mode links
• Carrier and service provider inter-site connections
• Long-distance campus and building-to-building links up to 40 km

Key specifications

• Interface: SFP+ small form-factor pluggable
• Data rate: 10 Gbit/s
• Fiber type: single-mode fiber
• Connector: LC duplex
• Maximum link length: up to 40 km (single-mode, depending on fiber and channel conditions)
• Optical type: bidirectional (BX) wavelength division for transmit and receive on single fiber
• Hot-swappable: yes

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your switch, router or media converter while the device is powered on or off, following the host equipment manufacturer’s guidance for hot-plug handling. Connect single-mode LC patch cords to the module, ensuring correct polarity and secure connector seating. Verify link status and configure the host interface for 10 Gbit/s operation if necessary. If the device or network requires specific configuration or monitoring, use the management interface of the host device to confirm optical parameters and link health.

Recommendations

Use high-quality single-mode fiber and LC patch cords, maintain proper connector cleanliness to avoid signal loss, and follow the transceiver and host device documentation for supported link budgets and wavelength pairing when deploying bidirectional (BX) optics over long distances.