Ομοαξονικός σύνδεσμος F-Typ ShiverPeaks BS15-300014

The ShiverPeaks BS15-300014 is an F-type coaxial connector designed to provide reliable RF connections for cable television, satellite and broadband installations. With a 6.7 mm outer diameter and a straightforward push-on or screw fitting to standard coaxial cables, this pack of 18 pieces is intended for installers and technicians who need consistent mechanical fit and signal transfer across multiple terminations.

Advantages

The connector offers a compact design and consistent mechanical tolerance that help maintain stable coaxial shielding and impedance. Constructed for repeated use in field or workshop environments, the connector supports low-loss signal transmission when properly installed and minimizes the risk of signal leakage and intermittent contacts. Supplied in a multi-pack of 18, it reduces the need for repeated ordering for small to medium projects.

Suitable for

• TV and satellite receiver installations
• Cable modem and broadband termination
• Residential and commercial RF distribution networks
• Bulk installation projects and service vehicle kits

Key specifications

• Connector type: F-type coaxial connector
• Outer diameter: 6.7 mm
• Quantity: 18 pieces per pack
• Electrical interface: standard 75 Ω coaxial connection (F-type compatibility)
• Typical use: screw-on or push-on termination for RG59/RG6 style coaxial cables

How to use

Prepare the coaxial cable by stripping the outer jacket, braid and dielectric to the recommended dimensions for an F-type termination. Slide the connector onto the prepared cable end and engage the central conductor so that it protrudes suitably into the connector pin area. Tighten or press the connector per the connector style until a secure mechanical and electrical contact is achieved. Check continuity and signal level after installation to confirm correct termination.

Recommendations

For best performance, use connectors with compatible cable types and maintain clean, corrosion-free contact surfaces. Avoid over-tightening to prevent damage to the connector body or cable conductor. Store unused connectors in a dry environment and handle with basic ESD precautions if working near sensitive electronic equipment.