Μονάδα πομποδέκτη SFP BlueOptics SFPGLX10B15D-w-BO 1250 Mbit/s

The BlueOptics SFPGLX10B15D-w-BO is a compact SFP transceiver module designed for fiber optic links with a maximum data transfer rate of 1250 Mbit/s. It is finished in silver and weighs approximately 20 g. The module uses the SFP interface and follows established MSA mechanical and electrical form factors to enable interoperability with compatible networking equipment.

Advantages

This SFP transceiver provides a standardized, hot-pluggable fiber interface for single-port uplinks or network expansions. Its small form factor and SFP interface allow flexible deployment in switches, routers and other network devices that accept SFP modules. The module’s fiber-based link reduces susceptibility to electromagnetic interference and supports reliable optical signal transmission over appropriate single-mode fiber cables. Lightweight construction and an industry-standard connector type make handling and installation straightforward.

Suitable for

• 1000 Mbit/s Ethernet and similar gigabit optical links
• Single-mode fiber point-to-point connections
• Replacing or expanding SFP slots in switches, routers and small form-factor appliances
• Environments that require EMI-immune optical links

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Connector type: LC simplex (optical interface; use compatible patch cords)
• Optical medium: single-mode fiber (recommended for long-distance optical links)
• Product colour: silver
• Weight: 0.02 kg

How to use

Install the transceiver by inserting it into a compatible SFP port while the host device is powered according to the device manufacturer’s instructions for hot-pluggable modules. Connect an appropriate LC single-mode fiber patch cable to the module’s optical connector, ensuring correct transmit/receive alignment. Verify link status on the host device and confirm negotiated speed and link parameters through the device management interface. Follow any vendor-specific guidance for firmware, module enablement or diagnostic access.

Recommendations

Use single-mode LC patch cords and, where available, enable digital diagnostic monitoring (DDM/DOM) on the host device to monitor supply voltage, temperature and optical power levels. Ensure that the host hardware supports the SFP module and the intended link speed. Handle the module by its housing, protect the optical interfaces from dust with dust caps when not connected, and follow standard ESD precautions during installation.