Μονάδα πομποδέκτη SFP BlueOptics SFP-25G-CLR-BO 25000 Mbit/s 1310 nm

The BlueOptics SFP-25G-CLR-BO is a single-mode fiber SFP transceiver module designed for high-speed networking. It supports a maximum data rate of 25,000 Mbit/s and operates at a nominal wavelength of 1310 nm. The module is housed in a metal casing, uses an SFP interface and a duplex LC connector, requires a 3.3 V supply and weighs approximately 3 g, making it compact and easy to install in compatible network equipment.

Advantages

This SFP transceiver delivers 25G data throughput over single-mode fiber with a standardized form factor that fits many network switches, routers and storage systems supporting SFP modules. Its metal housing provides mechanical durability and electromagnetic shielding while the lightweight design simplifies handling and installation. The module is designed to comply with industry MSA form-factor requirements for straightforward interoperability and supports optical transmission at 1310 nm for longer-reach single-mode links.

Suitable for

• 25G Ethernet uplinks between switches and routers
• High-bandwidth data center interconnects
• Single-mode fiber links requiring 25G speed over extended distances
• Upgrading compatible network ports to 25G capability

Key specifications

• Interface type: SFP
• Maximum data transfer rate: 25,000 Mbit/s
• Wavelength: 1310 nm
• Connector: LC duplex (single-mode fiber)
• Housing: metal casing
• Input voltage: 3.3 V
• Weight: approx. 0.003 kg
• Product colour: silver

How to use

Insert the BlueOptics SFP-25G-CLR-BO module into a compatible SFP port on your switch, router or storage device until it latches. Connect a single-mode LC duplex fiber patch cable to the module's connector, ensuring correct transmit/receive orientation. Power up the host device and verify link status through the device management interface. If supported by the host, enable or monitor digital diagnostics (DDM/DOM) to check operating parameters. Follow the host vendor’s instructions for firmware or module support requirements.

Recommendations

Use single-mode LC duplex patch cords and ensure the host hardware explicitly supports third-party SFP modules or the SFP form factor for reliable operation. Store and handle the transceiver with dust caps on the fiber ports when not in use and observe ESD precautions during installation. Verify link parameters and DDM/DOM support on the host to enable real-time diagnostics where available.