Microconnect SSTP60015G Καλώδιο δικτύου Πράσινο 0,15 m Cat6 S/FTP (S-STP)

The Microconnect SSTP60015G RJ-45 Cat6 0.15 m Green is a short, shielded networking cable for connecting devices such as switches, modems or routers to each other or to network infrastructure like patch panels, keystone jacks and wall outlets. This Cat6 S/FTP cable supports the Cat6 standard (tested up to 250 MHz), is backwards compatible with Cat5e and Cat5, and provides a compact 0.15 m length with green jacket and RJ-45 connectors on both ends.

Advantages

The S/FTP shielding reduces electromagnetic interference (EMI) and decreases crosstalk, helping to maintain data integrity and stable transmission rates. Latch protection on the RJ-45 plugs prevents connector damage during installation in tight spaces. The cable supports high data transfer speeds (up to 10000 Mbit/s as specified) and is suitable for modern high-speed network setups while remaining compatible with older standards.

Suitable for

• Short connections between network devices (switch, modem, router)
• Patching to patch panels, keystone jacks or wall outlets
• Small office and home network or entertainment wiring

Key specifications

• Standard: Cat6 (tested up to 250 MHz)
• Shielding: S/FTP (overall shield + individually shielded pairs)
• Connectors: RJ-45 to RJ-45
• Length: 0.15 m
• Data transfer rate: up to 10000 Mbit/s
• Colour: Green
• Weight: 0.01 kg

How to use

Plug each RJ-45 connector into the corresponding network ports on your devices or infrastructure points. Ensure connectors are fully seated until the latch clicks to establish a secure connection. Route the cable to avoid sharp bends and sources of strong electrical noise when possible. For installations in restricted spaces, use the latch protection to prevent damage during insertion.

Recommendations

For optimal performance, keep cable runs short or use this 0.15 m cable for direct device-to-device connections or patching. Avoid running the cable parallel and close to high-voltage power lines; if needed, use additional shielding or different routing to minimize EMI.