CBO SFP+ πομποδέκτης οπτικής ίνας J9151DCM-BO 10.000 Mbit/s 1310 nm

The CBO SFP+ Fiber Optic Transceiver J9151DCM-BO supports 10,000 Mbit/s data transmission over single-mode fiber at a wavelength of 1310 nm. Designed for insertion into SFP+ ports on switches, routers and servers, this module enables short- to medium-range optical links. It is intended for environments requiring reliable 10 Gbit/s fiber uplinks such as data centers, enterprise networks and aggregation points.

Advantages

This SFP+ transceiver provides a stable 10 Gbit/s connection with low power consumption and hot-pluggable operation for quick replacement or upgrades without system downtime. The module adheres to typical SFP+ form-factor standards to ensure compatibility with a wide range of networking equipment. Its 1310 nm wavelength supports longer reach than short-wave optics while maintaining signal integrity over multi-kilometer fiber segments when used within specified link budgets.

Suitable for

• 10 Gbit/s uplinks between switches in data center racks
• High-speed links between core and aggregation network devices
• Fiber connections for servers and storage area network (SAN) nodes
• Enterprise campus backbone links and point-to-point fiber spans

Key specifications

• Form factor: SFP+ (pluggable transceiver)
• Data rate: 10,000 Mbit/s (10 Gbit/s)
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber
• Connector type: LC duplex
• Operation: hot-pluggable
• Typical power consumption: low (SFP+ class)

How to use

Ensure compatible SFP+ ports and single-mode fiber cabling with LC duplex connectors are available on both ends of the link. Insert the transceiver into the SFP+ slot until it latches, then connect the fiber patch cord. After physical installation, verify link status and configure network interface settings on connected devices as required. For removal, follow hot-swap procedures recommended by the equipment vendor to avoid disrupting adjacent ports.

Recommendations

Use clean, certified single-mode fiber and LC connectors; inspect and clean fiber endfaces before mating to prevent signal loss. Check device compatibility lists or SFP+ host restrictions for vendor-specific interoperability. Observe manufacturer thermal and operating ranges and maintain proper fiber slack and bend radii to ensure stable 10 Gbit/s performance.