Αρθρωτό πομποδέκτη δικτύου BlueOptics 1442010G1-BO – οπτική ίνα, cSFP, 125 Mbit/s, αλουμίνιο

BlueOptics 1442010G1-BO is a compact fiber optic SFP transceiver module with a cSFP interface and a specified maximum data rate of 125 Mbit/s. Housed in an aluminium casing and weighing approximately 20 g, this single-port optical transceiver provides low-speed optical connectivity for networking equipment, media converters and embedded systems that require a small-form pluggable fiber interface. The module supports single-fibre optical links when used with appropriate cabling and compatible ports.

Advantages

The BlueOptics 1442010G1-BO offers a compact cSFP form factor that simplifies integration into devices with constrained space and standardized MSA-compatible electrical and mechanical interfaces. Its aluminium housing provides lightweight mechanical protection and passive heat dissipation. At a rated transfer speed of 125 Mbit/s the module is suitable for low-bandwidth optical links while maintaining signal isolation from electromagnetic interference inherent to fiber connections.

Suitable for

• Low-speed fiber links between switches, routers and media converters
• Embedded systems or industrial equipment requiring cSFP optical ports
• Single-port optical uplinks in small office or campus networks
• Applications where lightweight, compact optical transceivers are needed

Key specifications

• Interface type: cSFP
• Maximum data transfer rate: 125 Mbit/s
• Housing material: aluminium
• Weight: 0.02 kg
• Connector type: fiber optic (requires matching LC/other fiber connector on cabling or adapter)

How to use

Install the BlueOptics 1442010G1-BO by inserting the cSFP module into a compatible cSFP slot on the host device according to the device manufacturer’s insertion procedure. Ensure the host supports the module’s electrical and optical interface and configure the port settings for the intended 125 Mbit/s link if required. Connect an appropriate fiber optic cable or patch cord to the transceiver’s optical connector, taking care to match single-mode/multi-mode requirements of the link and to use correct connector types and polarity. Observe standard ESD precautions during handling and avoid exposing the optical connectors to dust or direct eye exposure to active optical transmitters.

Recommendations

Use clean, certified fiber patch cords and, where available, dust caps when the transceiver is not connected. Verify host compatibility and supported link speeds before deployment. For reliable operation, perform link tests after installation and follow the host vendor’s guidance for firmware or software settings affecting transceiver operation.