SFP-Transceiver οπτικής ίνας BlueOptics 569026-BO LC αλουμίνιο 20g

The BlueOptics 569026-BO LC Aluminium 20g is a single‑mode fiber optic SFP transceiver designed for 1000BASE‑LH applications. It uses an LC duplex connector and supports bidirectional optical transmission with a 1310 nm transmitter and receiver, offering single‑gigabit data transfer over long distances. Constructed with an aluminium housing and weighing approximately 20 g, this module is compatible with MSA‑compliant SFP ports and intended for integration into switches, routers, storage systems and other networking hardware that accepts standard SFP modules.

Advantages

The module delivers long‑reach fiber connectivity up to 40 kilometres for fiber links that require low latency and immunity to electromagnetic interference. It follows MSA standards for form factor and electrical/optical characteristics, enabling plug‑and‑play replacement in devices that support 1000BASE‑LH SFP transceivers. Built with high‑quality optical and electronic components, the transceiver provides consistent signal performance, support for digital diagnostics monitoring where host hardware allows, and a compact aluminium housing that facilitates heat dissipation with minimal weight.

Suitable for

• Long‑reach single‑mode fiber Ethernet links up to 1.25 Gbps
• Interconnection of switches, routers and storage systems across campuses or between buildings
• Replacement or expansion of existing SFP ports in MSA‑compliant network equipment
• Environments requiring immunity to electromagnetic interference and stable optical links

Key specifications

• Interface type: SFP (small form‑factor pluggable)
• Optical wavelength: 1310 nm (transmitter and receiver)
• Supported protocol: 1000BASE‑LH (Gigabit Ethernet) up to 1.25 Gbps
• Fiber type: Single‑mode fiber
• Connector: LC duplex
• Typical reach: up to 40 km (depending on fiber and link budget)
• Housing material: Aluminium
• Weight: approx. 0.02 kg
• Digital Diagnostics Monitoring (DDM/DOM): supported when host hardware provides the interface

How to use

Insert the BlueOptics 569026‑BO SFP into an empty, compatible SFP port until it latches; connect LC duplex single‑mode patch cords to the Tx and Rx ports, observing proper polarity. Ensure the host device supports 1000BASE‑LH and, if you require monitoring, that it exposes the DDM/DOM interface. Configure the connected equipment for the appropriate speed and duplex settings if manual configuration is required; most modern switches and routers will negotiate link parameters automatically. Verify link status and optical power levels through the host management interface or DDM readings, and route or switch traffic as needed.

Recommendations

Use high‑quality single‑mode fiber and properly rated LC patch cords to achieve the specified reach and link stability. Keep connectors clean and protected from dust, and avoid tight bends in fiber runs. If remote diagnostics are needed, confirm that the network device firmware supports DDM/DOM to access real‑time optical parameters for maintenance and troubleshooting.