Σετ τρυπανιών Bosch SDS plus-7X 6.5 x 200 mm, 10 τεμάχια

Set of 10 Bosch SDS plus-7X drill bits, each 6.5 x 200 mm, designed for use with SDS plus rotary hammer systems. These drill bits are intended for drilling into concrete, masonry and similar materials where consistent hole diameter and reliable bit retention are required. The 200 mm length provides sufficient working depth for through-holes and anchor installation while the 6.5 mm diameter is suited for common fixings and dowels.

Advantages

The Bosch SDS plus-7X geometry offers stable drilling progress and reduced vibration in rotary hammer mode, delivering uniform hole quality across multiple holes. Manufactured to meet Bosch quality standards, the set of ten identical bits ensures quick replacement on the job without searching for matching sizes. The shank and flute design promote efficient dust removal and consistent bit centring during drilling into hard substrates.

Suitable for

• Drilling holes for anchors and dowels in concrete and masonry
• Repeated identical holes on construction or renovation sites
• Professional and DIY projects that use SDS plus rotary hammers
• Installing services and fixtures where 6.5 mm hole diameter is required

Key specifications

• Type: SDS plus rotary hammer drill bits
• Diameter: 6.5 mm
• Total length: 200 mm
• Set quantity: 10 pieces
• Intended material: concrete, masonry and similar hard substrates

How to use

Fit the 6.5 x 200 mm SDS plus bit into the rotary hammer's SDS plus chuck until it locks. Select hammer drilling mode when penetrating concrete or masonry; use rotation-only mode only where hammering is not required. Apply steady pressure and allow the tool to advance at a controlled rate to avoid overheating the bit. Withdraw the bit periodically to clear dust from the hole and improve dust extraction if your tool is connected to a vacuum accessory.

Recommendations

Use appropriate personal protective equipment such as safety glasses, hearing protection and dust mask when drilling. Match drill speed and hammer action to the substrate, and replace bits when wear affects drilling performance or hole quality.