Πομποδέκτης SFP οπτικών ινών BlueOptics AA075999-BO 10000 m Αλουμίνιο

The BlueOptics AA075999-BO 10000 m Aluminium is an SFP fiber optic transceiver designed for single-mode fiber links up to 10,000 meters. Housed in a lightweight aluminium casing and weighing approximately 20 g, this module implements the SFP interface and LC duplex optical connector to support high-speed data transmission in networking equipment that accepts SFP modules. The module provides optical transmit and receive functions at 1310 nm and is designed to meet MSA form-factor and interoperability expectations for use in switches, routers and other network systems.

Advantages

The aluminium housing offers durable protection while keeping the module lightweight for easy handling and installation. Compliance with SFP mechanical and optical interface conventions ensures broad compatibility with equipment that supports standard SFP transceivers. Built to support single-mode fiber operation over long distances, the transceiver enables reliable point-to-point optical links without susceptibility to electromagnetic interference.

Suitable for

• Long-reach single-mode fiber uplinks between switches and aggregation devices
• Inter-switch connections in campus and carrier networks
• Fiber links for routers, storage systems and other SFP-compatible hardware
• Environments requiring lightweight, standard SFP optical modules

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Optical wavelength: 1310 nm (transmit and receive)
• Maximum reach: up to 10,000 m over single-mode fiber
• Connector type: LC duplex
• Typical application data rate: up to 1.25 Gbps (1000BASE-LX class)
• Material / colour: aluminium housing
• Weight: approximately 0.02 kg

How to use

Install the BlueOptics SFP transceiver into an SFP slot on compatible network hardware until it seats securely, and connect LC duplex single-mode fiber patch cables to the module's optical ports following transmit/receive orientation. Ensure the host device supports standard SFP modules and the relevant optical interface. After insertion, verify link status via the host device management interface and confirm proper optical power levels and link negotiation.

Recommendations

For optimal performance, use single-mode fibre rated for long-reach links and high-quality LC patch cords. Verify that the network device firmware or software supports third-party SFP modules and, where available, enable digital diagnostics (DDM/DOM) to monitor supply voltage, laser bias, optical output and input power, and temperature. Handle the module by the housing, avoid touching fibre endfaces, and keep protective caps on unused ports to prevent contamination.