Πομποδέκτης SFP BlueOptics SFPGLX10B15-w-BO 1250 Mbit/s οπτική ίνα

The BlueOptics SFPGLX10B15-w-BO is a single‑port SFP fiber optic transceiver designed for 1.25 Gbit/s (1250 Mbit/s) links. It has an SFP interface, a silver housing and a lightweight metal design (approximately 20 g). The module supports single‑mode fiber connections and uses an LC simplex optical connector for point‑to‑point transmission. It is intended for use in networking equipment that accepts SFP form‑factor transceivers and supports 1.25 Gbit/s optical interfaces.

Advantages

The transceiver follows MSA SFP form‑factor specifications for mechanical and electrical compatibility, enabling straightforward hot‑swap installation in compatible switches, routers and other networking devices. Its single‑mode LC simplex connection and 1.25 Gbit/s data rate make it suitable for typical gigabit optical applications while maintaining low weight and compact dimensions. The silver housing provides robust shielding and durability for rack or field installations.

Suitable for

• Gigabit Ethernet uplinks and optical links at 1.25 Gbit/s
• Connections between switches, routers, and optical patch panels over single‑mode fiber
• Data center interconnects and telecom links requiring LC simplex connectors
• Replacement or expansion of SFP‑based network ports in compatible hardware

Key specifications

• Interface type: SFP (Small Form‑factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s (1.25 Gbit/s)
• Optical fiber type: single‑mode fiber (SMF)
• Connector: LC simplex (optical)
• Typical application distance: designed for long‑reach single‑mode links (vendor datasheet reference for exact range)
• Housing colour: silver
• Weight: approx. 0.02 kg

How to use

Install the BlueOptics SFP transceiver into an empty SFP slot of a compatible switch, router or media converter while the host device is powered according to the equipment manufacturer’s instructions. Connect an LC simplex single‑mode patch cable between this transceiver and the corresponding remote transceiver or patch panel. Configure the host interface for the appropriate speed and protocol if required by the device (for example enabling 1.25 Gbit/s optical link or relevant transceiver settings). Monitor link status through the host device management interface to confirm successful negotiation and optical signal presence.

Recommendations

Ensure that the host hardware supports SFP modules and the targeted 1.25 Gbit/s optical protocols. Use single‑mode LC simplex patch cords and, where available, enable digital diagnostics (DDM/DOM) on the host device to monitor optical parameters. Observe ESD precautions when handling the module and keep protective caps on the optical connector when the transceiver is not in use.