Ομοαξονικό καλώδιο shiverpeaks Basic-S 1,5 m IEC λευκό

The ShiverPeaks Basic-S coaxial cable 1.5 m IEC White provides a straightforward connection solution for audio and video equipment. With IEC connectors on both ends and a 1.5‑metre length, the cable is intended for reliable RF signal transmission between TVs, set‑top boxes, FM/DAB receivers, and other household AV devices. The white jacket offers a neutral appearance that blends with light-coloured interiors and keeps installations tidy.

Advantages

This coaxial cable delivers consistent signal transfer with low loss over the 1.5 m distance and a standard IEC plug configuration for broad compatibility. The compact design and flexible outer jacket allow easy routing behind cabinets or along walls. The white finish reduces visual contrast near white appliances and décor, while the robust connector housings ensure stable mechanical contact during repeated installation and removal.

Suitable for

• Connecting a TV to a wall aerial or communal antenna point
• Linking set‑top boxes and satellite or cable receivers
• Connecting FM/DAB radio tuners to antennas
• Temporary or permanent AV installations in living rooms, bedrooms, or offices

Key specifications

• Cable length: 1.5 m
• Connector type: IEC male to IEC male
• Cable jacket colour: White
• Impedance: 75 ohm (typical for coaxial TV/RF use)
• Construction: Single coaxial conductor with dielectric insulation and outer shielding

How to use

Align the IEC connectors with the corresponding IEC sockets on your devices and push until they seat firmly; no tools are required for connection. Route the cable to avoid sharp bends and pinching points; allow a gentle bend radius near the ends to maintain signal integrity. For wall or furniture runs, secure the cable with cable clips or adhesive fasteners that do not crush the jacket. To disconnect, pull the connector body straight out from the socket rather than pulling the cable itself.

Recommendations

For best signal quality, keep the coaxial cable length as short as practical for your setup and avoid running it parallel to mains power cables to reduce potential interference. Inspect connectors for corrosion or damage before use, and replace the cable if the outer jacket or inner conductor shows visible wear.