Μονάδα πομποδέκτη SFP BlueOptics SFP-533-BO 10000 Mbit/s SFP+ 1310 nm

The BlueOptics SFP-533-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s (10000 Mbit/s) data transmission over single-mode fiber. It operates at a nominal wavelength of 1310 nm and uses an LC duplex connector in a compact metal housing. The module requires a 3.3 V supply and weighs approximately 3 g, making it suitable for space-constrained network equipment that supports SFP+ interfaces and 10GBASE-LR optical links.

Advantages

The module follows MSA-compliant SFP+ form-factor and LC duplex connectivity, enabling broad compatibility with network switches, routers and storage devices that accept SFP+ transceivers. Its metal housing provides mechanical robustness and thermal dissipation. Operating at 1310 nm, the transceiver is intended for long-reach single-mode fiber applications and supports 10 Gbit/s Ethernet signalling. Low input voltage and a very small weight simplify integration into densely populated chassis.

Suitable for

• 10GBASE-LR single-mode fiber links up to typical long-reach distances
• Upgrading switches, routers and storage systems to 10 Gbit/s
• Data center uplinks and inter-rack connections using LC duplex cabling
• Applications requiring MSA-compliant SFP+ transceivers

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 1310 nm
• Connector: LC duplex
• Power supply voltage: 3.3 V
• Housing: metal
• Weight: approx. 0.003 kg
• Colour: silver

How to use

Insert the SFP+ transceiver into an SFP+ port of a compatible switch, router or storage device until it seats firmly and the latch engages. Connect an LC duplex single-mode patch cord between this transceiver and the remote transceiver or patch panel, observing correct transmit/receive orientation. Ensure the host device supports 10G SFP+ modules and, if required by the system, enable or verify compatibility settings in the device firmware. Power is provided through the host interface (3.3 V), so no external power connection is necessary.

Recommendations

Verify that the target equipment supports third-party SFP+ modules and confirm that the DDM/DOM monitoring feature is supported by the host if remote diagnostics are needed. Use appropriate single-mode LC duplex fiber cabling and keep connectors clean to maintain signal quality and link reliability.