Μονάδα πομποδέκτη SFP BlueOptics BTI-SFP-GBD10L-55/31S-BO 1250 Mbit/s

The BlueOptics BTI-SFP-GBD10L-55/31S-BO is a compact SFP transceiver module designed for single-mode fiber optic links. It supports a data rate up to 1250 Mbit/s and operates at 3.3 V supply voltage. The module uses an LC (UPC) simplex connector and is intended for use in networking equipment that accepts MSA‑compliant SFP modules. With a maximum reach of up to 20 km over single-mode fiber, the transceiver is suitable for point-to-point links where bandwidth consistency and immunity to electromagnetic interference are required.

Advantages

The BlueOptics SFP module follows MSA standards for mechanical and electrical compatibility and is built for interoperability with a wide range of switches, routers and storage interfaces that support 1000BASE-BX-U style SFPs. It provides a compact form factor and low weight for easy hot‑swap installation. The LC (UPC) connector and single-mode design enable simultaneous transmit and receive optical channels on separate wavelengths, supporting common Ethernet and Fibre Channel over Ethernet applications up to 1.25 Gbit/s. The module’s specified range of up to 20 km makes it suitable for metropolitan and campus fiber links.

Suitable for

Key specifications

How to use

Install the SFP transceiver into a compatible SFP slot on your switch, router or media converter while the host device is powered according to the equipment manufacturer’s guidance for hot‑swap modules. Connect an appropriate single-mode LC patch cable to the LC (UPC) connector and ensure the transmit and receive ends are correctly paired to the remote transceiver (Tx to Rx). Verify link status and speed on the host device; if your equipment supports digital diagnostics (DDM/DOM), you can monitor supply voltage, laser bias current, optical output/input power and temperature through the management interface where supported.

Recommendations

For optimal performance, use single-mode LC patch cords of appropriate fiber grade and maintain clean connector endfaces. Confirm compatibility with your network hardware firmware and enable DDM/DOM monitoring only if supported by the system. Avoid mechanical stress on the fiber and follow ESD precautions when handling the module.