Μονάδα πομποδέκτη SFP BlueOptics 740-017726-BO 1310 nm LC 40000 m

The BlueOptics 740-017726-BO SFP transceiver module is a compact fiber-optic interface designed for single-mode links. Operating at a 1310 nm wavelength and fitted with an LC connector, this SFP form-factor module supports optical data transmission up to 40,000 m and weighs approximately 20 g. It is intended for use in systems that accept SFP transceivers and where a long-reach single-mode connection is required.

Advantages

This module delivers long-distance single-mode transmission at 1310 nm in a standardized SFP form factor and uses an LC duplex-style connector for optical connections. Its small size and 20 g weight make it suitable for densely populated networking hardware. The design follows common industry mechanical and electrical conventions, enabling interoperability with SFP-compatible ports that accept 1310 nm single-mode transceivers.

Suitable for

• Long-reach single-mode fiber links up to 40 km
• Switches, routers and transceiver slots that accept SFP modules
• Network uplinks and point-to-point optical connections
• Infrastructure where LC connector and 1310 nm wavelength are required

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Wavelength: 1310 nm
• Connector: LC optical connector
• Maximum transmission distance: 40,000 m (40 km)
• Fiber type: Single-mode
• Weight: approx. 0.02 kg
• Product colour: Blue, Grey

How to use

Insert the SFP transceiver into an empty SFP slot on a compatible switch, router or other networking device while the device is powered down or following the device vendor's hot-plug guidelines. Connect single-mode LC fiber patch cords to the module's LC connector(s), ensuring correct transmit/receive orientation. Configure the host device's interface settings as required by your network (speed, duplex, protocols). Verify link status through the host device's management interface and perform any required diagnostics.

Recommendations

Use high-quality single-mode LC patch cables and verify that the host hardware supports 1310 nm SFP transceivers. Keep fiber connectors clean and handle the transceiver by its housing to avoid contamination. Follow vendor guidance for hot-plugging and enable any available diagnostic or monitoring features on supported hardware to check optical power and link health.