Μονάδα πομποδέκτη SFP+ BlueOptics 57-1000493-01-BO 10000 Mbit/s

The BlueOptics 57-1000493-01-BO SFP+ transceiver module is a single-port optical interface designed for 10 Gbit/s fiber connections. It implements the SFP+ form factor with an LC duplex connector and a metal housing in silver color. The module supports a maximum data transfer rate of 10000 Mbit/s, is specified for single-mode fiber transmission, and offers a long mean time between failures (MTBF) of 1,000,000 hours while weighing approximately 20 g.

Advantages

This SFP+ transceiver follows MSA-compliant electrical and mechanical specifications, enabling interoperability with major networking hardware that accepts SFP+ modules. The metal housing provides mechanical robustness and thermal dissipation. Built-in Digital Diagnostics Monitoring (DDM/DOM) capability supports real-time monitoring of key operating parameters. The module is suitable for long-reach optical links and is manufactured to use quality optical and electronic components to ensure stable operation over extended service life.

Suitable for

• 10 Gbit/s Ethernet links over single-mode fiber
• High-speed uplinks and inter-switch connections in data centers
• Long-reach campus or metropolitan fiber links (up to specified single-mode distances)
• Fiber connections in routers, switches and storage systems that support SFP+

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Connector type: LC duplex (optical)
• Optical medium: single-mode fiber
• Module housing: metal, silver color
• Weight: approx. 0.02 kg
• Digital Diagnostics Monitoring (DDM/DOM): supported (MSA SFF-8472)
• Reliability: MTBF approx. 1,000,000 hours

How to use

Before installation, verify that your host device supports SFP+ transceivers and DDM if you intend to use monitoring features. Insert the BlueOptics SFP+ module into the SFP+ cage until it latches, then connect LC duplex patch cables to the module and to the remote transceiver or patch panel. Observe correct TX/RX orientation for the fiber pair. After physical connection, confirm link status on the host device and check diagnostic values via the device management interface when DDM is available. To remove the module, power down the port if recommended by the hardware vendor, release the latch and extract the transceiver carefully.

Recommendations

Use quality single-mode LC duplex patch cords and maintain clean fiber connectors to achieve rated range and signal quality. Confirm host compatibility and firmware support for third-party SFP+ modules where applicable. Avoid excessive mechanical stress and operate the module within the environmental limits specified by the host equipment.