Μονάδα πομποδέκτη SFP+ BlueOptics 0069-BO 10000 Mbit/s 850 nm

The BlueOptics 0069-BO SFP+ transceiver module provides a compact optical interface for 10 Gbit/s data links over multimode fiber. Operating at a wavelength of 850 nm, the module is designed for short-reach 10GBASE-SR applications and fits SFP+ ports with an LC duplex connector. It is RoHS-compliant, weighs approximately 20 g and is intended for integration into network switches, routers and storage equipment that support SFP+ optics.

Advantages

The module delivers 10,000 Mbit/s throughput with a standardized SFP+ form factor, enabling high-density deployment in racks and chassis. Its 850 nm multimode operation and LC duplex interface support simultaneous transmit and receive channels on separate fibers. Tested for interoperability with widely used hardware platforms, the BlueOptics 0069-BO emphasizes compact size, low weight and compliance with industry mechanical and optical standards.

Suitable for

• Short-reach 10G Ethernet links over multimode fiber (10GBASE-SR)
• High-speed uplinks between switches or to servers and storage
• Data center patching and aggregation ports with SFP+ slots
• Environments requiring RoHS-compliant optical transceivers

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Optical wavelength: 850 nm (multimode fiber)
• Connector: LC duplex
• Typical reach: optimized for short-reach multimode links (10GBASE-SR)
• Weight: approximately 0.02 kg
• Product colour: silver
• RoHS compliance: yes

How to use

Install the BlueOptics 0069-BO into an available SFP+ port with the module’s ejector/tab oriented according to the host device manual. Connect LC duplex multimode patch cords to the transceiver, ensuring correct transmit-to-receive fiber alignment between endpoints. After insertion the host system should detect the transceiver and negotiate link parameters at 10 Gbit/s if the connected equipment and cabling support 10GBASE-SR. Where supported by the hardware, enable or verify digital diagnostic monitoring (DDM/DOM) to view supply voltage, temperature, transmit and receive power and laser bias current for remote troubleshooting.

Recommendations

Use high-quality OM3/OM4 multimode fiber and LC duplex patch cords for reliable short-reach 10G links and to achieve the best signal margin. Verify that the host device firmware or OS supports third-party SFP+ modules and confirm DDM/DOM compatibility if you plan to use diagnostic monitoring. Handle the optical interfaces with care, keep dust caps on unused ports, and follow electrostatic discharge (ESD) precautions during installation.