Μονάδα πομποδέκτη οπτικών ινών BlueOptics S+31DLC10D-BO 10000 Mbit/s SFP+

The BlueOptics S+31DLC10D-BO is a fiber optic SFP+ transceiver module designed for 10G data transmission over single-mode fiber. It supports a maximum data transfer rate of 10000 Mbit/s and uses an LC duplex connector with 1310 nm transmitter and receiver wavelengths suitable for long-reach links. The module follows MSA (Multi-Source Agreement) electrical and mechanical specifications and is compatible with MikroTik hardware that supports 10GBASE-LR SFP+ modules. It is certified to industry standards including RoHS, CE, FCC and is produced under ISO9001 quality procedures.

Advantages

The BlueOptics S+31DLC10D-BO offers reliable 10G connectivity with low weight (approx. 20 g) and industry-standard SFP+ form factor, enabling easy installation in compatible switches, routers and storage systems. The module incorporates proven optical and electronic components and supports digital diagnostic monitoring (DDM/DOM) to report parameters such as supply voltage, laser bias current, output and input power, and temperature. Compliance with MSA standards ensures interoperability with a wide range of network hardware.

Suitable for

Key specifications

How to use

Install the BlueOptics S+31DLC10D-BO into a compatible SFP+ port until it latches according to the host device instructions. Connect LC duplex single-mode fiber patch cords to the module, ensuring transmit and receive fibers are correctly crossed at each end. Verify link status in the host device and, if supported, read DDM/DOM values to confirm optical power levels and module health. Follow the network equipment vendor’s guidance for enabling and configuring the SFP+ port and ensure firmware or software compatibility with third-party transceivers where required.

Recommendations

Use high-quality single-mode fiber and LC duplex patch cords to achieve the expected reach and signal margin. Confirm that the target MikroTik or other vendor hardware supports third-party 10GBASE-LR SFP+ modules and enable DDM/DOM monitoring if remote diagnostics are needed. Avoid exposing the transceiver to excessive dust or mechanical stress during installation and keep unused modules in protective caps when not in use.