Μονάδα πομποδέκτη οπτικών ινών BlueOptics RDH-1025/3-BO 10000 Mbit/s SFP+

The BlueOptics RDH-1025/3-BO is a 10G SFP+ fiber optic transceiver module designed for single-mode fiber links. It supports a maximum data transfer rate of 10000 Mbit/s and uses LC duplex connectivity for simultaneous transmit and receive over separate fibers. The module is supplied in a silver housing and complies with CE, RoHS and FCC standards. With a compact SFP+ form factor and a lightweight design, it is intended for use in switches, routers, storage systems and other network equipment that accepts 10G SFP+ transceivers.

Advantages

The module provides reliable 10 Gigabit Ethernet and compatible high-speed protocols such as Fibre Channel over Ethernet and SDH/SONET up to typical link distances supported by 10GBASE-LR optics. It is manufactured to MSA SFP+ mechanical and electrical specifications and is tested for compatibility in multi-vendor environments. The transceiver supports digital diagnostics (DDM/DOM) for real-time monitoring of supply voltage, laser bias current, output and input optical power and temperature when the host hardware supports these functions. Its small form factor and conformity to international safety and environmental standards simplify integration and deployment.

Suitable for

Key specifications

How to use

Install the transceiver into a compatible SFP+ port on your switch, router or storage system by pushing the module into the cage until it latches. Connect LC duplex single-mode fiber patch cords to the transceiver's LC ports, ensuring correct orientation for transmit and receive. Verify link status in the host device and check digital diagnostic values if supported by your hardware to monitor operating parameters. Follow the equipment manufacturer's instructions for hot-plug handling and observe electrostatic discharge (ESD) precautions during installation and removal.

Recommendations

Use high-quality single-mode LC duplex patch cords and, where possible, route fibers through patch panels to protect connections. Confirm that the host device firmware or software permits third-party SFP+ modules and that DDM/DOM functionality is enabled if remote monitoring is required. For long-term reliability, avoid excessive bending of fiber cables and operate the transceiver within the ambient temperature and voltage ranges specified by your system vendor.