Μονάδα πομποδέκτη οπτικής ίνας BlueOptics PN59023-BO 10000 Mbit/s SFP+

The BlueOptics PN59023-BO 10000 Mbit/s SFP+ is a compact fiber optic transceiver module designed for high-speed 10G connections over single-mode fiber. Housed in a silver SFP+ form factor and weighing approximately 20 g, this module supports 10GBASE-LR optical transmission with LC duplex connectors and operates at 1310 nm for both transmitter and receiver. It is built to meet MSA standards and is suitable as a replacement in systems that accept the original PN59023 transceiver, enabling reliable data transfer across distances up to 10 km when deployed with appropriate single-mode cabling.

Advantages

The module provides 10 Gbit/s data rate in a standard SFP+ form factor, enabling straightforward integration into switches, routers and storage systems that support SFP+ uplinks. Compliance with MSA mechanical and electrical standards ensures interoperability across a wide range of network equipment. Built from quality optical and electronic components, the module offers a long operational lifetime, stable optical performance and lower susceptibility to electromagnetic interference compared with copper-based links. Digital diagnostics (DDM/DOM) support allows remote monitoring of key parameters such as supply voltage, laser bias current, transmit/receive power and temperature where the host hardware exposes this functionality.

Suitable for

Key specifications

How to use

Install the BlueOptics PN59023-BO into an available SFP+ slot on compatible network equipment until it clicks into place, and connect LC duplex single-mode fiber patch cords to the module following the transmit/receive labeling. Ensure the host device supports 10GBASE-LR optics and, if DDM/DOM monitoring is required, verify that the hardware and firmware provide access to diagnostic data. After physical installation, configure the interface in the host system as needed (enable the port, set speed/duplex or relevant link settings) and verify link status and optical power levels through the host management interface.

Recommendations

Use high-quality single-mode LC duplex patch cords and, where possible, route fibers through proper patch panels to minimize bending and connector contamination. Confirm compatibility with the specific hardware platform and firmware version before deployment, and perform an initial optical power and diagnostics check to validate link margin. For installations requiring high availability, consider keeping spare modules and maintain regular monitoring of DDM parameters to detect degradations early.