Μονάδα πομποδέκτη οπτικής ίνας BlueOptics OPT-0039-BO QSFP28 LC

The BlueOptics OPT-0039-BO QSFP28 LC is a fiber optic transceiver module designed for 100G high-speed data transmission. It uses a QSFP28 interface with an LC duplex connector and is finished in aluminium. The module is intended for single-mode fiber links and weighs approximately 40 g. It is built to meet MSA-compliant mechanical and electrical form-factor expectations and to operate in networking equipment that accepts QSFP28 optical modules.

Advantages

This QSFP28 LC transceiver provides a compact 100G form factor suitable for dense, high-bandwidth links. Its aluminium housing contributes to mechanical durability and thermal conduction. The module supports standard optical transmission over single-mode fiber and is compatible with equipment that supports MSA-style QSFP28 optics. Built and tested to conform with accepted component selection and interoperability practices, the module is intended to deliver stable, long-term operation in production networks.

Suitable for

• 100G Ethernet aggregation and core links
• High-performance switching and routing platforms that accept QSFP28 optics
• Data center interconnects over single-mode fiber
• Storage and backup systems requiring 100G optical interfaces

Key specifications

• Interface type: QSFP28
• Connector: LC duplex
• Optical medium: single-mode fiber
• Typical supported data rate: 100 Gbps
• Housing material: aluminium (product colour: aluminium)
• Weight: 0.04 kg
• Form factor: QSFP28 MSA-compliant transceiver

How to use

Install the BlueOptics OPT-0039-BO QSFP28 LC into a compatible QSFP28 port on a switch, router or other network device while the host system is powered down or following the manufacturer's hot-plug procedures. Connect LC duplex single-mode fiber patch cords to the transceiver's LC connector, respecting transmit/receive orientation. Ensure the host device firmware or driver supports third-party QSFP28 modules and, if required, enable digital diagnostics monitoring (DDM/DOM) in the host to monitor real-time parameters such as optical power and temperature. Follow the equipment vendor instructions for link configuration and testing after installation.

Recommendations

Use single-mode LC patch cords of the appropriate attenuation and quality and route fibers to minimize bend loss. Verify compatibility with the specific network hardware and enable DDM/DOM if the system supports it to monitor module status. For long-term reliability, operate the module within the host device's specified environmental and power ranges and perform periodic link testing as part of routine maintenance.