Μονάδα πομποδέκτη οπτικής ίνας BlueOptics JL783A-BO SFP+ LC αλουμίνιο

The BlueOptics JL783A-BO SFP+ LC Aluminium is a fiber optic transceiver module designed for 10G optical links using an LC duplex connector. Built to the MSA SFP+ form factor, the module is compatible with hardware that supports 10GBASE-LR transceivers and is constructed in an aluminium housing weighing approximately 20 g. It transmits and receives optical signals over single-mode fiber using a 1310 nm wavelength and is intended for reliable high-speed data transmission across campus and data center links.

Advantages

The module follows MSA standards for SFP+ transceivers, ensuring interoperability with a wide range of network equipment that accepts 10GBASE-LR SFP+ modules. Its aluminium housing provides mechanical durability while keeping weight low. Designed for long-distance single-mode operation, it supports simultaneous transmit and receive via an LC duplex connector and is suitable for applications up to several kilometers when used with appropriate single-mode fiber. The transceiver also supports digital diagnostic monitoring (DDM/DOM) when the host hardware enables this feature, allowing real-time monitoring of optical power, temperature and supply conditions.

Suitable for

Key specifications

How to use

Insert the BlueOptics JL783A-BO SFP+ module into a compatible SFP+ port on your switch, router or network appliance until it latches. Connect an LC duplex single-mode fiber patch cable to the module, observing proper Tx/Rx orientation. Ensure the host device is configured for 10G operation and that any required firmware or software settings allow third-party transceiver modules. If digital diagnostic monitoring is required, verify that the host system supports DDM/DOM and enable any necessary monitoring tools to read optical parameters.

Recommendations

Use high-quality single-mode fiber patch cords and maintain clean LC connectors to ensure optimal signal quality. When deploying multiple links, verify compatibility with the specific hardware platform and test links after installation. For long-term reliability, avoid mechanical stress on the transceiver and fiber and operate within the temperature and voltage ranges specified by the host device.