Module πομποδέκτη οπτικής ίνας BlueOptics LSP422-BO 10000 Mbit/s SFP+

The BlueOptics LSP422-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s optical links. It implements an SFP+ interface in a compact silver housing and supports single-mode fiber connections with LC duplex connector compatibility. The module is intended for use in high-speed network equipment where a 10GBASE-LR class optical transceiver is required and provides a lightweight solution (approx. 20 g) with a long-rated mean time between failures for reliable operation.

Advantages

The module supports a maximum data transfer rate of 10000 Mbit/s over single-mode fiber and conforms to the mechanical and electrical SFP+ form factor, enabling straightforward integration into compatible switches, routers and storage systems. Its LC duplex optical interface enables simultaneous transmit and receive channels on separate fibers. A high MTBF rating indicates suitability for continuous network operation and reduced maintenance frequency. The silver housing and standard SFP+ connector make the module compatible with common installation practices and rack-mounted networking hardware.

Suitable for

• 10 Gbit/s Ethernet links (10GBASE-LR) over single-mode fiber
• High-speed uplinks between switches and routers
• Interconnects for storage systems and data center equipment
• Long-reach optical links where LC duplex connectors are used

Key specifications

• Interface: SFP+ form factor
• Maximum data rate: 10000 Mbit/s (10 Gbit/s)
• Optical type: single-mode fiber, LC duplex connector
• Typical weight: 0.02 kg
• Housing colour: silver
• Reliability: rated mean time between failures ~3,000,000 hours

How to use

Install the transceiver into an available SFP+ port on the target device, ensuring the module is fully seated and the device supports 10GBASE-LR optics. Connect LC duplex single-mode fiber patch cords to the Tx and Rx ports following the device labeling. After insertion, verify link status and negotiated speed via the host device management interface. If the host supports Digital Diagnostic Monitoring (DDM/DOM), enable and read diagnostics through the device software to monitor optical power, temperature and supply voltage as available.

Recommendations

Use single-mode LC duplex patch cords of appropriate attenuation and quality, keep connectors clean and protected, and verify hardware compatibility with the host device to ensure reliable 10 Gbit/s operation. For long-term stability, monitor diagnostic parameters where supported and follow manufacturer guidance for handling and ESD precautions.