Κοπτικό FEIN 63502225210

The FEIN 63502225210 cutter attachment is a precision accessory designed for use with compatible multi-tools. Engineered to make controlled cuts in plasterboard, various plastics and soft wood, the cutter has a cutting length of 50 mm and a blade width of 65 mm. Supplied as a single piece per pack, this attachment is intended to deliver accurate trimming and profiling where clean edges and dimensional control are required.

Advantages

This cutter attachment provides accurate cutting performance for thin building materials and softer wood types. Its compact blade dimensions allow close-to-surface work and confined-space access. The combination of a 50 mm cutting length and 65 mm width balances reach and stability, reducing the likelihood of tearing or splintering during straight and controlled cuts. As a dedicated tool for multi-tools, it installs quickly and keeps replacement simple.

Suitable for

• Cutting and trimming plasterboard and drywall panels
• Shaping and trimming plastic sheets and profiles
• Small crosscuts and trimming of soft wood components
• Detail work where a narrow, controlled cut is required

Key specifications

• Cutting length: 50 mm
• Blade width: 65 mm
• Material compatibility: plasterboard, plastic, soft wood
• Pack contents: 1 cutter attachment

How to use

Fit the cutter attachment to a compatible FEIN or universally compatible oscillating multi-tool following the tool manufacturer's mounting instructions. Secure the attachment and check that the tool is powered off before installation. Mark the cutting line on the workpiece, hold the tool steadily, and start at low speed to guide the blade into the material. Increase speed as needed for a smoother cut, keeping steady forward pressure and avoiding lateral force that could stress the blade or cause chipping. After use, allow the attachment to cool if warm and inspect the cutting edge for wear before storing.

Recommendations

Use appropriate personal protective equipment, including safety glasses, hearing protection and a dust mask. For best results on plasterboard and plastics, use moderate speed settings and light, steady passes. Replace the cutter when cutting quality declines or when visible wear or damage appears on the blade.