Καλώδιο SFP+ BlueOptics SFP-AOC-10G-25M-FR-BO 25m Βύσμα/Βύσμα

The BlueOptics SFP-AOC-10G-25M-FR-BO is a 25-metre SFP+ active optical cable engineered for reliable 10 Gigabit Ethernet and other high-speed interconnects. With male SFP+ connectors on both ends, this AOC (active optical cable) provides a plug-and-play solution for direct connections between SFP+ ports on switches, servers and storage devices. The optical design reduces electromagnetic interference and maintains signal integrity across short to medium rack and data centre distances.

Advantages

This active optical cable offers low latency and consistent 10 Gbps throughput while eliminating the need for separate transceivers and fibre patch cords. Its factory-terminated connectors simplify installation and reduce compatibility issues. The lightweight and bend-tolerant construction improves cable management in dense rack environments and reduces power consumption compared with some copper direct-attach alternatives.

Suitable for

• Interconnecting SFP+ ports between switches, routers and servers
• Top-of-rack and end-of-row data centre connections
• High-performance computing clusters and storage area networks (SAN)
• Short-reach 10 Gigabit Ethernet links within cabinets and between adjacent racks

Key specifications

• Length: 25 metres
• Interface: SFP+ male to SFP+ male
• Data rate: 10 Gbps
• Cable type: Active optical cable (AOC)
• Connector polarity: duplex
• Low-latency optical transmission suitable for rack and data centre environments

How to use

Ensure both devices support SFP+ interfaces and 10 Gigabit links before installation. Power down or follow hot-swap procedures recommended by your network equipment vendor, then insert the male SFP+ connectors into the corresponding ports until they latch. Verify link status through the device management interface or status LEDs and configure the network ports as required. For removal, disengage the latch and withdraw the connector carefully to avoid stressing the cable or port.

Recommendations

Route the cable to avoid sharp bends and high-stress points; maintain the manufacturer’s minimum bend radius to preserve optical performance. Use proper cable management in racks to prevent tension on connectors and to ensure airflow. Check firmware and compatibility notes for network equipment if link negotiation or vendor locking is encountered.