Digitus FTTH προκατασκευασμένο καλώδιο έγχυσης LC/APC 10 m Singlemode 1 ίνα

The pre-assembled blow-in cable is a lightweight, factory-terminated fiber optic cable designed for fast FTTH deployment. It features pre-polished connectors and a compact, low-friction construction that allows air-assisted blow-in installation in microducts without splicing on site. Bend-insensitive fiber maintains signal quality in tight bends, making the cable suitable for last-mile connections and residential or small business fiber runs.

Advantages

The cable comes with high-performance pre-terminated connectors, eliminating the need for on-site splicing or connector assembly and reducing installation time and potential failure points. Its bend-insensitive fiber and low friction jacket provide reliable performance in confined ducts and tight routing paths. The compact design and compatibility with blow-in installation tools enable efficient, repeatable deployment in FTTH network expansions.

Key specifications

• Factory pre-terminated polished connectors — no splicing required
• Bend-insensitive single-mode fiber for reduced bend loss
• Lightweight, low-friction jacket suitable for air-assisted blow-in in microducts
• Compact construction for last-mile and FTTH installations

How to use

Prepare the microduct route and ensure ducts are clean and free of obstructions. Use compatible air-assisted blow-in equipment to insert the pre-assembled cable into the microduct, monitoring feed speed and air pressure according to the blower manufacturer’s guidelines. Once in place, verify connector integrity and make optical tests at endpoints to confirm insertion loss and continuity before commissioning.

Recommendations

Store the pre-assembled blow-in cable on suitable reels and avoid sharp bends or crushing. Follow blower and connector manufacturer instructions for air pressure, feed rate, and pulling/feeding procedures. Perform optical loss and end-face inspections after installation to ensure reliable FTTH performance.