BlueOptics JNP-SFP-10G-BX20D-BO Μονάδα πομποδέκτη δικτύου 10000 Mbit/s SFP+

The BlueOptics JNP-SFP-10G-BX20D-BO network transceiver module is an SFP+ form-factor fiber optic module designed for 10 Gbit/s links. It uses an LC simplex connection and implements the 10GBASE-BX-D transmission scheme with separate wavelengths for transmit and receive, making it compatible with hardware platforms that support the corresponding SFP+ MSA profile. The module is finished in silver, is compact and lightweight, and carries regulatory compliance for RoHS, FCC and CE. With an MTBF of 3,000,000 hours, it is intended for reliable, long-term optical connectivity in data center and enterprise networking environments.

Advantages

The module supports a 10,000 Mbit/s data rate over an SFP+ interface, enabling high-speed uplink and interconnect applications while maintaining the compact SFP+ form factor. Its LC simplex connector and bidirectional 10GBASE-BX-D design (separate transmit and receive wavelengths) simplify fiber usage by allowing single-fiber or paired-fiber deployments depending on system requirements. Compliance with RoHS, FCC and CE standards and a high MTBF value indicate predictable operational behaviour and suitability for continuous operation in managed network infrastructures.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP+ transceiver into an SFP+ slot on a supporting switch, router or compatible line card following the host device manufacturer's hot-plug procedure. Connect the LC simplex fiber patch cord according to the required transmit/receive orientation: the module transmits on the specified wavelength and receives on the complementary wavelength. Verify link status in the host device management interface and confirm that the port is configured for 10 Gbit/s operation. Observe electrostatic discharge precautions when handling the module and keep dust caps on the connector when not in use.

Recommendations

Use single-mode fiber or the fiber type specified for the target reach and ensure that fiber polarity matches the module's TX/RX wavelengths. Confirm compatibility with the host device firmware and, where required, enable corresponding SFP+ profiles in Juniper-compatible systems. Store unused transceivers in antistatic packaging and maintain connector cleanliness to preserve optical performance.