InfiniBand Ενεργό οπτικό καλώδιο CBO QSFP-AOC-10M-MR-BO 10 m

The InfiniBand Active Optical Cable CBO QSFP-AOC-10M-MR-BO 10 m is a factory-terminated QSFP form-factor cable designed for high-speed InfiniBand links across a 10 meter distance. Intended for data center interconnects and direct server-to-switch connections, the cable integrates active optical transceivers within the cable assembly to deliver low-latency, high-bandwidth optical transmission without the need for separate plug-in transceivers. The design provides a single-cable solution that simplifies rack cabling and reduces connector density while maintaining signal integrity over a multi-meter span.

Advantages

This active optical InfiniBand cable offers secure optical transmission with lower electromagnetic interference compared with copper alternatives and supports long-reach connectivity within server rooms and racks. Factory termination and an integrated QSFP interface reduce installation time and eliminate compatibility issues associated with separate transceivers and fiber patching. The cable is engineered for low latency and stable data throughput, making it suitable for latency-sensitive applications and dense networking environments.

Suitable for

• Server-to-switch links inside racks and across adjacent racks
• Data center top-of-rack and leaf-spine interconnects
• High-performance computing clusters requiring low-latency links
• Environments where simplified cabling and reduced connector count are required

Key specifications

• Form factor: QSFP (Quad Small Form-factor Pluggable) integrated in cable ends
• Cable type: Active Optical Cable (AOC) with integrated transceiver electronics
• Length: 10 m optical link
• Application: InfiniBand high-speed data links
• Transmission: Optical single-mode/multi-mode characteristics suitable for short to medium reach (factory-configured)
• Latency: Designed for low-latency operation suitable for performance-critical networks
• Connector interface: QSFP form-factor on both ends for direct port connection

How to use

Install the cable by inserting each QSFP connector directly into the corresponding QSFP ports on networking equipment or server network adapters. Ensure that both ends are fully seated and latched according to the host device instructions. Because the cable contains factory-installed optical transceivers, no additional transceiver modules or fiber patch cables are required. Verify link status and data rate on connected equipment after insertion and follow any equipment-specific procedures for optical link negotiation or firmware compatibility.

Recommendations

Route the cable with gentle bends, avoiding sharp kinks and excessive pulling force. Maintain clear airflow around ports and avoid placing stress on the QSFP housings. Use cable management to prevent strain and reduce the risk of connector damage. For reliable operation, confirm compatibility of QSFP ports with integrated active optical cables in device documentation and ensure firmware supports AOC connectivity where required.