Τρυπάνι σκάλας Bosch 2608597643 εξάγωνο στέλεχος 1,4 cm

The Bosch 2608597643 auger drill bit with a hex shank and 1.4 cm diameter is designed for efficient drilling in a wide range of wood types, including soft, hard and even wet wood. It is a single-piece bit for use in drills with a 13 mm chuck and is intended for tasks such as through-holes, pre-drilling for rafter nails and creating deep dowel holes, providing precise, stable results and a fine surface finish.

Advantages

Precision-ground construction ensures dimensional stability while drilling. The optimised flute geometry enables a fast drilling rate and effective chip removal. High break resistance gives reliable durability in demanding woodworking applications. The hex shank allows secure fitting in chucks and quick bit changes.

Suitable for

Key specifications

How to use

Install the Bosch 2608597643 auger bit into a drill with a 13 mm chuck, ensuring the hex shank is fully seated and tightened. Mark the drilling point on the workpiece, start at low speed to locate the hole and then increase speed as appropriate for the wood type. Use steady pressure and allow the bit to cut; clear chips by withdrawing periodically on deep holes. For through-holes, continue until the desired depth is reached.

Recommendations

Wear appropriate eye and hearing protection, and secure the workpiece before drilling. Use recommended drill speeds for the specific wood type and avoid excessive side load to reduce the risk of bit breakage. Inspect the bit for wear or damage before use and replace if necessary.